Best Way To Attach Shutters To Vinyl Siding

The larger hole will allow for expansion and contraction.

Best way to attach shutters to vinyl siding.

However when properly installed shutters can last for years with little maintenance. The vinyl siding hooks are made of plastic and worked perfectly to hang my light weight metal wall decor. When improperly installed damage to the shutters and siding can result in overwhelming repair costs. And so as long as you re careful about the way they attach you certainly can have shutters on top of vinyl.

If your shutters do not have holes for screws you should place them near the top of the sidebars. Hold your shutters up and drill an 1 8 pilot hole through the holes where your screws were. The addition of shutters to a home can add curb appeal and style. Take shutter down and drill hole slightly larger than screw diameter through hardi plank then stop.

Then take the shutter down and drill a 3 8 hole and only drill through the vinyl siding don t drill into your sheathing. You do want to be careful not to squish the siding because remember the siding is somewhat soft. Others may have a different method. Measure the same distance upward from the bottom of your shutters and make a mark on your siding for the next screw.

Shutters are also a reflection of personal taste and complete the look of a home s exterior. Approximately 5 inches from the shutter s top is an ideal location for screws. So what i wanted to do is i wanted to put shutters on the house but i m not sure which color or which style. How to attach board and batten shutters to vinyl siding we used long screws and attached the shutters right through the siding and into the wood beneath.

But the only way to fasten the shutters is to drill into the siding. When you re ready to hang things on your vinyl siding push the curved part of the hook between the siding panels. If your shutters are exposed to a lot of moisture it would be a good idea to caulk well around the screw holes with a clear weatherproof caulk. Use a hammer to gently tap the fasteners to snug the shutter to the siding.

I was wondering if it could be a do it yourself project. Screws should be long enough to go through shutter then hardi plank and have about 1 left to go.